NOTE : This is a 230 Volt AC, Single Phase Pump. For other AC votages please inquire - This is NOT available in 115 Volt

Based on the same basic design as the drainage pumps, the sludge pumps come into action when the liquid gets dirtier than can be handled by the drainage pumps. The design even permits converting between drainage and sludge models allowing you to adapt the pump according to the varying conditions. Maximum solids pump can pass are 2 inches

Materials :
• Casted parts: Aluminium
• Outer casing: Stainless steel
• Motor shaft: Stainless steel
• Impeller: Hard-Iron
• Pump housing: Aluminium/Polyurethane
• O-rings: Nitrile rubber
• Screws and nuts: Stainless steel

Features:
•Discharge connection is 3 inch hose, as well as 3 inch NPT or ISO-G threads
• Rated current at 230 Volts, 1 Phase, is 9.9 Amps
•Shaft seals :
-Cartridge seal: pre-assembled double mechnical seal running in an oil compartment
- Material lower seal: silicon carbide - silicon carbide
- Material upper seal: tungsten carbide - aluminium oxide

Limitations :
•Max. submersion depth: 20 m (66 ft)
• Max. liquid temperature: 40 degrees C (104 degrees F)
• Allowed pH range: 5 - 8
• Maximum solids pump can pass are 2 inches

Pump Dimensions :

Performance Curve :