Jabsco # 2620-1101 Bronze Pedestal Pump

The Jabsco 2620-1101 is a bronze Flexible Impeller pump with a Neoprene Impeller, Nitrile Lip Type seal, 3/8 Inch NPT Internal Ports, bare shafted pedestal pump end only without a Motor. The Neoprene impeller in this pump can be used for water and general-purpose pumping. Temperature limits for Neoprene impellers are 45 degrees F to 180 degrees F ( 7 degrees C to 82 degrees C). This pump has a nominal flow rate of 20 Litres/min (4.4 gallons/min) at 1500rpm, and is self-priming from dry up to 1.5m (4.9 feet) and primes at low or high speeds. For vertical lift of 10 feet (3.0mm), a minimum of 800 RPM is required. Pump will produce suction lift of up to 22 feet (6.7m) when wetted. Be sure suction lines are airtight or pump will not self-prime. This unit depends on liquid pumped for lubrication. Do Not Run Dry for more than 30 seconds. Lack of liquid will damage the impeller and the pump components. Pump may be mounted in any position. Intake and discharge ports are determined by the direction of shaft rotation. Before installing, turn the pump shaft in the direction of the operating rotation.

To avoid pump damage, do not use petroleum based anti-freeze compounds or rust inhibitors.