Jabsco part # 6056-0001

The Jabsco 6056-0001 is an Impeller Neoprene for a Jabsco Pump. DISASSEMBLY 1. Remove end cover and end cover gasket. 2. Remove impeller. 3. Loosen cam screw and remove cam. Clean off sealant. 4. Remove wearplate with screwdriver or hooked wire. 5. Loosen nut at body clamp and remove body from motor. 6. Press out seal from motor mounting end of body towards impeller bore. 7. Slide O-ring off shaft. NOTE: Inspect all parts for wear or damage and replace, if necessary. When returning pump to factory for repair, do not send motor unless it requires replacement. It is suggested that you contact local motor manufacturer's distributor for service. ASSEMBLY 1. Press seal into seal bore with lip facing toward the impeller bore. 2. Install wearplate, aligning slot with dowel pin in body. 3. Apply a thin coat of sealant to top of cam and cam screw threads. Install cam and secure with cam screw. 4. Lubricate impeller bore with water pump grease and install impeller in body. Use care not to damage seal lip with impeller sleeve. 5. Install gasket and end cover, securing with end cover screws. 6. Install 0-ring on motor shaft and position 1/4 Inch from motor boss. 7. Apply a liberal coating of grease to the 0. D. of the motor shaft. 8. Align ding in impeller with shaft keyway and install on motor. 9. Secure nut at clamp. Do not overtighten.