Little Giant catalog # 502303, 2E-NDVR Small Submersible Industrial Pump, Double Viton Seal Acid Handling Pump, Oil-filled, Direct Drive, rated for 300 GPH gallons per hour at 1 foot of head open flow. Motor is 1/40 Horsepower, 115 Volts, Single Phase. Motor has a 6 foot cord. Inlet Port is 1/4 inch MNPT Outlet port, Discharge Port is 1/4 inch MNPT Outlet port.
Price : $ 261.75
The Little Giant 502303 is a 2E-NDVR Small Submersible Industrial Pump, Double Viton Seal Acid Handling Pump, Oil-filled, Direct Drive, rated for 300 GPH gallons per hour at 1 foot of head open flow, with a 1/4 inch MNPT outlet port, coupled to a 1/40 Horsepower, 115 Volt, single phase Motor that has a 6 foot cord. This is a Double-Viton seal acid pump that can be used submerged when pumping water or machine oils and should be used in-line (not submerged) when pumping weak acids and chemicals, fruit juice, cleaning solvent, anti-freeze and fluids with a pH factor of 6 to Nylon volute with a 3/8" FNPT intake (nylon 1/2" barbed hose adapter included) and 1/4" MNPT discharge. Stainless steel plate and motor shaft with inner and outer Viton seals. Thermally protected motor. The pump's housing and cover are made from epoxy coated aluminum; its volute and impeller, nylon; and its shaft seal, Vipers. This pump uses two Viton shaft seals, a 1/2 inch barbed hose adapter, a 1/40 HP motor, thermal protections, a 3/8 inch FNPT intake, and a 1/4 inch MNPT discharge. It can pump liquids with a maximum temperature of 120 F
WEIGHT : The Little Giant 502303 weighs 5 Lbs.
There are many applications that the Little Giant 502303 are used in. Typical applications for this pump include Submersible for pumping water or machine oils. Inline when pumping weak acids and chemicals, fruit juices, cleaning solvent, antifreeze and fluids with a pH factor of 6 to 7.
To install, seal the power cord inside of liquidtight, 1/2 inch NPT steel intermediate metal conduit. Use caution to ensure that cord will not be nicked or cut. Consult pump nameplate data for proper voltage and frequency. Please note, the black or brown and white or blue wires are live and the green or green/yellow wire is ground. Be sure that the pump is fully submerged in the cleaning solvent. The pump power supply cord must be connected to a properly grounded, groundingtype receptacle. WARNING Do not allow the pumps power cord to come in contact with solvent. The solvent may damage the cord insulation, causing the cord to become stiff or lower its insulating properties. The pump is supplied with a threeconductor power cord. The third conductor is to ground the pump to prevent possible electrical shock hazard