Little Giant # 526003 NK-1 Submersible Industrial Pump 1/150 HP
Little Giant # 526003
Little Giant catalog # 526003, NK-1 Small Submersible Industrial Pump, Oil-filled, Direct Drive, rated for 210 GPH gallons per hour at 1 foot of head open flow. Motor is 1/150 Horsepower, 115 Volts, Single Phase. Motor has a 6 foot cord. Inlet Port is 1/4 inch MNPT Outlet port, Discharge Port is 1/4 inch MNPT Outlet port.
Price : $ 162.75
Product Information :
Parts Page (click here)
Specsheet PDF (view)
The Little Giant 526003 is a NK-1 Small Submersible Industrial Pump, Oil-filled, Direct Drive, rated for 210 GPH gallons per hour at 1 foot of head open flow, with a 1/4 inch MNPT outlet port, coupled to a 1/150 Horsepower, 115 Volt, single phase Motor that has a 6 foot cord. This is a small submersible oil-filled pump with epoxy coated cast aluminum housing. For commercial, industrial and home applications including statuary fountains, water displays, air conditioners, machine tool coolants, and many other applications where liquid must be transferred or recirculated. This compact 810 GPH pump features a 1/2" MNPT discharge, 24.5' shut-off head capability, and screened inlet. This pump uses a 1/150 HP oil-filled motor and a 1/4 inch MNPT discharge. It can pump liquids with a maximum temperature of 120 F. The pump's shaft seal is made from Viton; its housing, cover, volute and impeller, nylon; and its screen, polyethylene. This pump uses a corrosion resistant nylon body, an oil-filled motor, a 1/4 inch MNPT discharge, and thermal overload protections. It has a 10.2 foot maximum lift, and it requires 70 watts of power. It is designed specifically and exclusively to be used in submersible applications
WEIGHT : The Little Giant 526003 weighs 3.67 Lbs.
Features :
Applications
There are many applications that the Little Giant 526003 are used in. Typical applications for this pump include Submersed or inline use, water transfer or recirculation, water displays, machine tool coolants, and mild acids.
This pump may be used submerged or inline. It may be positioned at any attitude, but preferably with the volute located down or to the side. The weight of the pump must be supported adequately. DO NOT support the pump by the discharge connection alone. The pump may be supported by using the two mounting holes in the back of the pump. These holes accept 8 selftapping screws. Hole depth is.37" DO NOT exceed the hole depth. Do not restrict the intake side of the pump. This may cause damage to the seal and may starve the pump. For reduced flow rates, place a valve on the discharge side of the pump, or if flexible vinyl tubing is used a clamp on the tubing to restrict the flow. Do not let the unit operate dry. It is cooled by pumping fluid. You may damage the seal and the motor may fail if the pump is allowed to run dry. If the unit is going to be idle for a period of time, follow the cleaning instructions outlined in the usr manual. Do not let the unit freeze, as this may cause cracking or distortion that may destroy the unit