Little Giant catalog # 527176, NK-2 Small Submersible Industrial Pump, Oil-filled, Direct Drive, rated for 325 GPH gallons per hour at 1 foot of head open flow. Motor is 1/40 Horsepower, 115 Volts, Single Phase. Motor has a 18 foot cord. Inlet Port is 1/4 inch MNPT Outlet port, Discharge Port is 1/4 inch MNPT Outlet port.
Price : $ 226.50
The Little Giant 527176 is a NK-2 Small Submersible Industrial Pump, Oil-filled, Direct Drive, rated for 325 GPH gallons per hour at 1 foot of head open flow, with a 1/4 inch MNPT outlet port, coupled to a 1/40 Horsepower, 115 Volt, single phase Motor that has a 18 foot cord. Small submersible oil-filled pump with corrosion resistant nylon housing. For commercial, industrial and home applications including statuary fountains, water displays, air conditioners, machine tool coolants, and many other applications where liquid must be transferred or recirculated. This compact 325 GPH pump features a 1/4" MNPT discharge, 12.3' shut-off head capability, and screened inlet. This pump can pump liquids with a maximum temperature of 120 F. It uses a 1/40 HP oil-filled motor, and a 1/4 inch MNPT discharge. The pump's screen is made from polypropylene; its housing, cover, volute and impeller, nylon; and its shaft seal, Viton. This pump uses a corrosion resistant nylon body, an oil-filled motor, a 1/4 inch MNPT discharge, and thermal overload protections. It has a 12.3 foot maximum lift, and it requires 100 watts of power. It is designed specifically and exclusively for submersed applications
WEIGHT : The Little Giant 527176 weighs 5.17 Lbs.
There are many applications that the Little Giant 527176 are used in. Typical applications for this pump include Submersible, water transfer or recirculation, water displays, machine tool coolants, and mild acids.
This pump may be used submerged or inline. It may be positioned at any attitude, but preferably with the volute located down or to the side. The weight of the pump must be supported adequately. DO NOT support the pump by the discharge connection alone. The pump may be supported by using the two mounting holes in the back of the pump. These holes accept 8 selftapping screws. Hole depth is.37" DO NOT exceed the hole depth. Do not restrict the intake side of the pump. This may cause damage to the seal and may starve the pump. For reduced flow rates, place a valve on the discharge side of the pump, or if flexible vinyl tubing is used a clamp on the tubing to restrict the flow. Do not let the unit operate dry. It is cooled by pumping fluid. You may damage the seal and the motor may fail if the pump is allowed to run dry. If the unit is going to be idle for a period of time, follow the cleaning instructions outlined in the usr manual. Do not let the unit freeze, as this may cause cracking or distortion that may destroy the unit