Little Giant # PE-2YSA Small Submersible Industrial Parts Washer Pump 1/40 Horsepower
Little Giant # PE-2YSA
Little Giant catalog # PE-2YSA, Catalog # 518550, Small Submersible Industrial Parts Washer Pump, Oil-filled, Direct Drive, rated for 300 GPH gallons per hour at 1 foot of head open flow. Motor is 1/40 Horsepower, 115 Volts, Single Phase. Motor has a 6 foot cord. Inlet Port is 1/4 inch MNPT Outlet port, Discharge Port is 1/4 inch MNPT Outlet port.
Price : $ 144.75
Product Information :
The Little Giant PE-2YSA is a catalog # 518550, Small Submersible Industrial Parts Washer Pump, Oil-filled, Direct Drive, rated for 300 GPH gallons per hour at 1 foot of head open flow, with a 1/4 inch MNPT outlet port, coupled to a 1/40 Horsepower, 115 Volt, single phase Motor that has a 6 foot cord. This is a small submersible epoxy encapsulated pump for commercial, industrial and home use. Applications include statuary fountains, water displays, air conditioners, machine tool coolants, and many other applications where liquid must be transferred or recirculated. This compact 475 GPH pump features a 1/4" MNPT discharge, 13.4' shut-off head capability, screened inlet and a 6' power cord. The pump has a maximum flow rate of 475 GH at 1 foot, a maximum head of 13.4 feet, and can pump liquid with a maximum temperature of 120 F. It requires 115 V at 60 HZ, and it uses a 1/28 HP epoxy-encapsulated motor. It's housing and cover are made from glass-filled polyester; its volute, polypropylene; its impeller, Nylon; its shaft seal, Viton; and its screen, polyethylene. It uses a screened intake, and a 3/8 inch discharge. This pump is designed specifically and exclusively for submersible applications. It uses an epoxy-encapsulated, direct drive motor. It has a capacity of 300 GPH at 1 foot
WEIGHT : The Little Giant PE-2YSA weighs 4.5 Lbs.
Features :
Applications
There are many applications that the Little Giant PE2YSA are used in. Typical applications for this pump include Water transfer or recirculation, and water displays.
This pump may be used submerged or inline. It may be positioned at any attitude, but preferably with the volute located down or to the side. The weight of the pump must be supported adequately. DO NOT support the pump by the discharge connection alone. The pump may be supported by using the two mounting holes in the back of the pump. These holes accept 8 selftapping screws. Hole depth is.37" DO NOT exceed the hole depth. Do not restrict the intake side of the pump. This may cause damage to the seal and may starve the pump. For reduced flow rates, place a valve on the discharge side of the pump, or if flexible vinyl tubing is used a clamp on the tubing to restrict the flow. Do not let the unit operate dry. It is cooled by pumping fluid. You may damage the seal and the motor may fail if the pump is allowed to run dry. If the unit is going to be idle for a period of time, follow the cleaning instructions outlined in the usr manual. Do not let the unit freeze, as this may cause cracking or distortion that may destroy the unit